Re: Some problems with the pm system
[Re: cohunt]
#6929697
07/14/20 02:44 PM
07/14/20 02:44 PM
|
Joined: Dec 2006
Posts: 2,445 revillo, sd
cohunt
OP
trapper
|
OP
trapper
Joined: Dec 2006
Posts: 2,445
revillo, sd
|
Well, we gained a bit. The one address is defunct. Could that email address in some fashion be stuck in the tman system and causing the problem that I began with?
Last edited by cohunt; 07/14/20 02:44 PM.
|
|
|
Re: Some problems with the pm system
[Re: cohunt]
#6929703
07/14/20 02:48 PM
07/14/20 02:48 PM
|
Joined: Dec 2006
Posts: 17,550 Rodney,Ohio
SNIPERBBB
trapper
|
trapper
Joined: Dec 2006
Posts: 17,550
Rodney,Ohio
|
Even if that were the case, it could not explain how Ken's message with the correct address timed out before getting to me. The odd thing is that the email reply you sent to me, your email is unsecured. Dunno if that does anything for the tman issue
|
|
|
Re: Some problems with the pm system
[Re: cohunt]
#6929717
07/14/20 03:03 PM
07/14/20 03:03 PM
|
Joined: Dec 2006
Posts: 16,493 Goldsboro, North Carolina
Paul Dobbins
"Trapperman custodian"
|
"Trapperman custodian"
Joined: Dec 2006
Posts: 16,493
Goldsboro, North Carolina
|
Paul: If you can remove the tnics address and replace with the one i provided by PM, that might help some. Your email DID NOT come through. did you use the tnics for that attempt? It won't let me change that one.
|
|
|
Re: Some problems with the pm system
[Re: cohunt]
#6929719
07/14/20 03:03 PM
07/14/20 03:03 PM
|
Joined: Dec 2006
Posts: 2,445 revillo, sd
cohunt
OP
trapper
|
OP
trapper
Joined: Dec 2006
Posts: 2,445
revillo, sd
|
Paul: When I registered was when I still had my crank computer. I replaced that with a battery version years ago.
Last edited by cohunt; 07/14/20 03:04 PM.
|
|
|
Re: Some problems with the pm system
[Re: Paul Dobbins]
#6930731
07/15/20 03:14 PM
07/15/20 03:14 PM
|
Joined: Aug 2007
Posts: 5,792 Sauk County, WI
Patrice
"TMan Feed Gestapo "
|
"TMan Feed Gestapo "
Joined: Aug 2007
Posts: 5,792
Sauk County, WI
|
I apologize for jumping in late on this discussion and possibly being redundant, but I have done this to myself numerous times when I was in a hurry. When trying to email a post or thread (not a PM) to myself, I click the Email Post button on the thread below one of the posts and get the screen captured by Paul below. I typed in my email address at the arrow and it worked for me. In a hurry, I see my own email address already filled into the field above Paul's arrow and do not even notice the field Paul is pointing to which must be filled out with the email address for sending the post or thread. At the bottom of that screen I click Send Email and the following confirmation screen pops up momentarily ... That screen starts with a message saying Email Has Been Sent but if you look quickly before the message disappears and you are returned to the forum, it reports that An email of this post has been sent to . (Note the space where the email address would have appeared, but there is none because I did not fill one into the field Paul pointed out. In other words, it has been sent nowhere. Sometimes I repeat that whole failed operation a few times quickly before I slow down and see what I omitted. In stark contrast, if I am reading a PM and click the Email Thread To Me button, the PM thread is immediately emailed to the email address I have stored for this site and it appears in my email without any further input on my part. Maybe that will help a few of you, Patrice (Others may have to look at whose ISP might be blocking a series of IP addresses - that's a load of fun!)
WTA District 9 Director ... Go D9! Member: WTA, Intertel, Mensa (Trappers ain't stupid.) Life Member: NRA
|
|
|
|
|