To show that the switch is still on

Riiiiiiiiiiiiight !! Easier said than done

You know you need to call in an electrician , when your electrical system looks like this:

Add some 3 Phase 480 in there, and you are good to go !

The Pass Seymour 692, is wired with white wire on silver screw, feed hot wire on the same side of Switch as the neutral wire, on the brass or dark screw and the switch leg to the light on the other side of the switch. The reason two screws on the same side have continuity is if you want to use it as a Constant light on in a dark area. Then you would put the line side/hot wire on the screw that share continuity which feeds the pilot light.

If you need me to walk ya through it shoot me a pm and I’ll give you my number.

Yes. This was the problem I switched the incoming hot to the opposite side and everything works as designed. Their instructions are terrible. But I was trying to make it more complex than it is

I sure appreciate all the help and MOST of the comments

What he said