OUCH!, one of the loops came off of a 220 conibear and I had forgot my safety device, I was able to wiggle my thumb out, nothing broken though.What tools does everyone carry to help get out of one?

thanks

Ouch.
At least it wasnt a 330.

small coil of rope with a loop in both ends --- mine is usualy baling twine and meant for a one time use.

Wrap some light guage wire around those safety’s ...so they stay in place..like in the pic

Did it hurt right away??? My old boss used to ask me that when i hit my thumb with a hammer!

some safeties can use a little more bend your lucky only 1 came off i've had to drive a plastic felling wedge in a 160 to wiggle out 330's i use those wire re-bar ties around the jaws when your in the clear snip it

Ouch

The only thing keeping that tight is the rust.lol.

yup it sure did, LOL

Trapper Ron's safety setter

I'm not sure that I understand the rebar ties, could you explain it a little more? where is exactly do you wrap it on, is the twist pointing to you? do you do it before you set the trigger? I am a little slow LOL

It smarts. Hopefully you're not setting your 220 on land in ark.

Just reading the title made me wince!

That's gotta be a sharp intake of breath event?

Where do we send your membership card. Must be renewed every year.

Slow down. Pay closer attention. Keep your parts out of the danger zone.

We all have gotten our junk caught in our zipper. ONCE!

We did not then begin to carry extra equipment to dejunk our zippers did we? Nope. Best lessons are learnt the hard way.

no, I was doing a water set, my first time for beaver

Added Carry strap so there's no excuse to leave it behind.

330-Trapper, I like how you put that flagging tape on the spring. I have that same great setter, but am bummed because I lost the spring the other day.

It has happen to everyone sooner or later, if not it will.