Wolfgang's have worked for me in sand muck and hard ground. Only use 12 inch on my land line hard Rocky ground here. Use 18 inch in muck and sand. I welded a T- handle piece of pipe on my driver. In muck and sand no hammer needed, I push in to the handle and pull out.

Where can order a long driver to get down deep hold a beaver in sandbar on cable stake on snare ? Or loose sand up creek bank ?

Thinking about get some for next season in longer lengthe cable an driver with pipe weld on for anchor deep water or an for spring beaver snare in sand , how well wolf fangs hold in sand bar with beaver on snare , or how far should have stake push in? Wolf fangs best ?

Decided to build a few cable stakes and a driver for Ben to anchor his beaver snares with this year. He has trouble pulling them long poles, so I figured he could just cut these if he can't get them pulled. This system is not for hard ground but it works great in water sets.





I used 4 1/2" pieces of 1/2" ID conduit. Mash one end shut with a hammer and drill a small hole for my 30" of 3/32" 7x7 cable.

The driver is just a piece of 1/2" rod 36" long with a piece of heavy 1" pipe for a T-handle and a nut welded on the top where the rod comes through the handle in case he needs to pound on them some. A scrap piece of the conduit keeps the driver from going too far into the stake heads.







He'll just use my short coon snare stakes with the #9 to support the snares.

Clean shop