ok gang......I don't own a welder............but is it possible ,,,to make your own double jaw 1.5 coils without welding? ive got tons of 1.5 coils........I just don't want to have to break down to buy a few more dozen WITH the double jaw .............I just have some situations were blind sets are gonna shine............and would feel more comfortable using the double jaws.

Why not? Only limited by your imagination. A drill and some bolts along with some flat bar and a hack saw.

Id go buy a $100 welder. I have an el cheapo northern tool 110 and it does a decent job.

you could rivet them

I know most weld a rod lamination , but a flat stock clamped , drilled and riveted could work not pop rivets , crush rivets

Bend the tips is another option right

You could take fault stock bed the eds to their flush against the inside of the jaws for like half inch on each side.
Your gonna clamo and drill a hole on those just sides and the jaw then pop rivit them

Here's what I meant


See how the tips are flushed up to the jaw ? You come front he other side drill you two holes and pop rivet em twice

Now that is a fantastic idea!!

That will work.
Then you may be able to spread that out a bit by driving chisel between the two pieces of metal. Or you could place a spacer between the two ends to get more space between the jaws. But then you would have to have a real rivet. But a 6 or 8 penny nail will work as a rivet.

Just use two traps at each location. They will have a heck of atime with two legs tied up.......jk