Spilled oil on concrete floor

Long line of bar oil on concrete floor of barn. 2”x2O ft. Too embarrassed to explain how. Would like to clean up with temps 20-35
Thanks

Spread oil-dri on it. Then follow up with brake clean and rags.

Lacquer thinner and a rag.

Brake Clean

Some info here :
https://www.concretenetwork.com/fix-concrete-cleaning/removing-embedded-oil.html

Thanks again.

Gotta get them caps on tight.

This

Or remember to put the cap on to begin with. lol

Been there done that.

Your worried about a little oil on the floor?

39 yrs here and no oil on floor.

Product called Simply Green. Cheap and works!

I tell all my customers to use dawn dish soap anything else can make it soak in the soap will lift it out .

Oil dry followed with a chemical of your choice and some elbow grease.

Large amounts, I scoop with shovel first and then oil dry.

Me too, that was my first thought as to what caused the spill.

I did the same thing two weeks ago but it was on dirt.

You and I won't do it again.

Pete

Kitty Litter and Muriatic Acid, be careful with the acid- dilute 1 part acid to 4 parts water

Two gaskets on oil filter - my guess. Happened to me once.

Wipe up what you can. Put some dawn dish soap on the oil, add some water and go over it a few times with a broom. Wipe up and you are good to go.

Get some pure cement spread out on stain it will suck most of it up

If the saw would have been in the other hand it would not have been so long. LOL

put mineral spirits on the floor and then floor dry, Let it sit for a long while to dry and it will pull oil up into floordry clay,

I generaly use wood ashes let set a few days and scrape it around a couple times lifts most things out of the concrete use it for blood and oil

brake cleaner - soak it. poor on the oil dry, and scrub it in with a small piece of board (2x4). It will go away fast, then sweep it up

Ahhhh......don't worry about it , it's a ' real man stain ' . Real men get greasy , dirty and do real work. Symbol of pride , check off one mark on your ' man card '

Ever get covered in sawdust working or cutting wood ?
Sawdust = man glitter

Oil dri for 24 hours, but the secret is to grind in the oil dri. Don't just toss some on, grind it in to the oil with your boot. Then sweep it up and scrub with dawn dish soap, or better yet some sort of solvent.