Dead BuckTooth flooders

Re make MB750


Damage control ADC

Good job!!

Right on, good job

Good job 330. I see you use MB750's. I like the traps but I am having issues with ring offs. I have been using cable drowners and see you are using rods. Do you think that would be the difference?

Nice work! Those Belisles are nasty!

To Backroadarcher: Rods take them down to deep water faster than cable is what I found.

Those beaver are dead.

Nice that's the way to stack them up. Are they saleable?

Could be, more flex in cable.

I've used Wire in the 80's
cable and Chain in the 90's
re-rod and or Fiberglass rods Since 200!

one I Thought about mouth to mouth ...but Alas I decided against it

If I was going to target the front foot I would use a smaller trap. The bigger the trap the more likely it is to hang up, and not turn with the beaver. If the trap spins with the beaver there is no way it can ring off. I have held beaver alive in a 1 3/4 by a front foot more then once..

I agree but I also use Bridger #5 coil spring and have never even had a broken leg.????

I've NEVER ever had a Beaver wringing off in my MB 750'S

That is good to know. I am going to build a couple of drowning rods. Thanks 330 and keep getting them!!

10' Re rod is heavier but works great with an angled piece of condit for a slide

I don't know where to buy more Fiberglass rods like I got years ago

Very nice 330

Thanks Pawnee

You got it figured out.
Looks fun.

Great catch

nice job.