Posted By: yack
Sauvageau body grip pan problems - 11/20/18 10:00 PM
I have some old Sauvageau 120 sized body grippers.
Originally they had a pan mounted on them
I took the pans off, and replaced them with wire triggers.
I want to convert them back to the original pan setup.
I'm old now, so can't remember how the whole pan system worked.
They have a pc of rod welded to the pan, with a pc of 1/2" pipe welded horizontally on the bottom of the rod, pan on top.
There are a couple of rivets holding a trigger of sorts.
Before I snap one on my fingers, I was wondering if somebody out there could post a pic of how they are attached to the trap, and set?
I'll get it eventually, but I might be in pain at the end of the lesson. LOL
Jim
Originally they had a pan mounted on them
I took the pans off, and replaced them with wire triggers.
I want to convert them back to the original pan setup.
I'm old now, so can't remember how the whole pan system worked.
They have a pc of rod welded to the pan, with a pc of 1/2" pipe welded horizontally on the bottom of the rod, pan on top.
There are a couple of rivets holding a trigger of sorts.
Before I snap one on my fingers, I was wondering if somebody out there could post a pic of how they are attached to the trap, and set?
I'll get it eventually, but I might be in pain at the end of the lesson. LOL
Jim