Skinnin’ setups

Post your skinnin’ setups/machines
I’ve built some of these in the past for trappers such as Sam Wood, Robby Gilbert and even Charlie over at Hoosier Trapper Supply. I made a trailer receiver attachment also. Sam has a buck hangin off of it in a video several years ago. 12v system can be taken anywhere and remote control.

Couple photos of mine i made out of a old basketball hoop. Big sturdy steel pipe with lots of square tubing i bought as well for supports and the top pulley to hang all together was really cheap less than 200 i think to make including the winch which runs off a 12v battery or could be hand winched. I then have at the base with the cylinder the clamps which i have two spots drilled out one lower for coyotes and one at the top for raccoons and smaller animals so you aren't bending down too much and allows for the machine to do most of the work. Then i spray painted it and the base was painted many many times to help stop it from rusting as i want this to last a very long time.

Low-tech, but works great on weasel, rats, mink and even beaver while working the head area.

Homemade base with bolt/nut in center post, so it swivels. Harbor freight winch.





I also made a swivel clamp similar to rendezvous'-

I use a 12 volt atv winch and hook to battery charger when I use it. 11 ft tall with a rts gambrel. Also, I now use one of MonsterToms roller clamps. That thing works great.