how do you store them vertical or flat

Mine hang on the uni-strut rail just like when they have fur on them.

do you guys treat them with anything I have some that got mold on them I sprayed with bleach but was thinking of treating them

I hang them using unistrut

that's nice

where did you get hanger or did you make them

Rendezvous, that shop is disgustingly clean!

If a little mold bothers you, wipe down with W-D 40. Storing in a less humid area helps too.

I hang mine with eye hooks in the bottom of the stretcher, rats has a small hole drilled in the nose of the board which hang on cup hooks.

During season, vertical next to where I need them. Rest of year, in the loft out of the way. Put them flat, stacked 15 or so high. Would like to think this also helps to keep them from warping.

I lay all mine down (wood) up in the rafter section of my garage. I used to varnish them all and quit doing that has putting in pins got harder. If you want to wipe them down, buy a gallon of degreaser at a building or farm store and mix with some warm water and wipe down.

Bryce

mine are all hanging upside down.

then i stack my beaver boards on top to help prevent warpin.

Trapper Dahlgren you can buy that metal clip at Menards or a box building store in the electrical dept. It is a conduit clamp used for unistrut to hang conduit usually on a commercial job. The clamp is 2 pieces just fasten one half to a stretcher, you can get 2 stretchers per clamp.

I have insulated, finished ceiling.
Garage door hangers & 2x4's. Finish nail to hang fur.
Storing in the off-season...


Then leaning against wall in-season

nice john deere