Fresh snow this morning and no moisture in forcast today!!!

33deg high of 45, cloudy with light winds!!!!

Should b easy to see.

You guys priming with 3F, will it run through your pan primer? Or do you use something else?

I prime with on of these:

You've convinced me, !'ll start looking for one similar.

I just prime from my horn. Not sure if 3F will work in those little valve primers.

That's what I use. This is the first year I used 4F. Always just used 3F because I didn't want to buy a whole pound of 4F. Had a friend give me a bit of 4F for fixing a muzzleloader for him.

Good to know CoonsBane. I'll fill it with some 3F and see how it goes.

Hey lugnut..your pm box is full. Tried to send you a pm

I cleared some out Nessie, should go through now.

I don't use a primer like that very anymore... 3f works in those but not nearly as smooth as 4f. May take a couple tries to get the amount you want to dispense.

I also found that not pushing the plunger into the pan helped things flow smoother... I would put my thumb over the end, turn it upside down and push the plunger a few times. Then dump the prime in the pan... That prevented scooping any soup into the end of the plunger and caking it up.

Mike