|
Knee problems
#6925226
07/09/20 06:01 PM
07/09/20 06:01 PM
|
Joined: Aug 2014
Posts: 1,336 SE MN
2cylinder
OP
trapper
|
OP
trapper
Joined: Aug 2014
Posts: 1,336
SE MN
|
Any of you guys have your knee pop out of place Slightly and then it'll pop back into place? A few months back my leg got tangled up in a tractor and thats the first time it popped out place, but then it went back to normal so I wouldn't worry about. I can walk and run on it fine but if I bend to the side funny or something hits it from the side it'll pop outta place just a little bit and I hit it back into place and its fine again. Anyone with any other experiences like this.
Rebuilding john deere and international/farmall carburetors
|
|
|
Re: Knee problems
[Re: AJE]
#6927147
07/11/20 03:02 PM
07/11/20 03:02 PM
|
Joined: Aug 2014
Posts: 1,336 SE MN
2cylinder
OP
trapper
|
OP
trapper
Joined: Aug 2014
Posts: 1,336
SE MN
|
That is an odd 1.
Hopefully your local clinic can help you out, without needing surgery. Yes it is, I asked a bunch of other people and they got no clue. So I'm going to try and go to the doc next week
Rebuilding john deere and international/farmall carburetors
|
|
|
Re: Knee problems
[Re: 2cylinder]
#6929734
07/14/20 03:17 PM
07/14/20 03:17 PM
|
Joined: Sep 2010
Posts: 6,591 NC, Orange Co.
QuietButDeadly
trapper
|
trapper
Joined: Sep 2010
Posts: 6,591
NC, Orange Co.
|
Sounds like you probably need a good ortho doc to check it. May need an MRI to see if you have a partial tear of some kind that can be fixed with a scope or even exercise.
Mine did not pop out as you describe but would buckle once in a while. Turned out to be a complete tear of my ACL.
Life Member: NCTA, VTA, NTA, TTFHA, MFTI Member: FTA NRA NWTF
|
|
|
Re: Knee problems
[Re: QuietButDeadly]
#6930411
07/15/20 07:57 AM
07/15/20 07:57 AM
|
Joined: Aug 2014
Posts: 1,336 SE MN
2cylinder
OP
trapper
|
OP
trapper
Joined: Aug 2014
Posts: 1,336
SE MN
|
Sounds like you probably need a good ortho doc to check it. May need an MRI to see if you have a partial tear of some kind that can be fixed with a scope or even exercise.
Mine did not pop out as you describe but would buckle once in a while. Turned out to be a complete tear of my ACL. Hmmm interesting, I suppose I should look into it a little deeper.
Rebuilding john deere and international/farmall carburetors
|
|
|
|
|
|