But that’s a beautiful wolverine! Good luck getting your sled fixed up and back out there.
When you are setting a line approximately how many lynx and wolverine sets are you able to put out in one day? How many miles are you running?
Always amazed at how hard you go and are able to keep it up throughout the season.
Before the Lynx crashed I would go out to my camp the first trip after freeze up and haul wood, ice fish for bait and set anywhere from 3-20 traps. It was more of a preparation trip with a few traps to look at the following weekend. I usually opened trails too and shovelled a lot of snow to smooth out some steep river banks that I had trails by. The following weekend I aimed for 50 new traps and snares set. 330 boxes, mb 750, and #3’s. Always in the same places that connect so less guess work. Then every weekend after that I would fill a bag with traps and set them. 5-6 new sets every weekend until I was out of traps. High traffic locations would get 2-3 traps and usually 4-6 snares. These were places I knew would get multiple Lynx coming through. Anywhere from singles to big family groups. Other locations would get a single trap and always at least 2 snares. Those were places that got dependable traffic but not what I would call high traffic. Usually big adult singles occasionally 2-3 travelling together. A snare on the way to the trap and one on the walking trail past the trap for those pesky trap refusals. Most Lynx sets were on top the river bank in the shelter so snow wouldn’t drift then over. Very tiring sometimes walking up the steep and usually high banks. Some of the loops I was running were easier through chain lakes and over land trails with less jumping on and off the skidoo to climb banks If I remember right I was doing about 350km total in a weekend when I had every line going from Friday as early as possible until Sunday as late as possible a lot of times getting back just in time to make it to school or work around 8am Monday morning. A lot of times I had long distances between sets. More efficient in the long run to only set the good places for Lynx, wolf and wolverine. Long answer but I got to reminiscing about the good old days. I would’ve been finished the front feet on this wolf I’m working on tonight. I could keep going and add more details as they pop into mind but it’s 149am and I’ve got this wolf to get on the board.
A way shorter answer couldve been that I usually aim for 20-25 Lynx cubbies built in a day with as many snares as I feel like setting. I think I had 65-70 #3s back then. Usually made trails in the daylight and set them up by head lamp for efficient use of my time.