You could use a speed square to get your 60+ degree angle then cut with a circular saw. Unless you are talking bevel cuts.

Just turn your 2x on edge, alot nicer cut. Jmo

Yep bevel cut is the word. ,yeah I tried the deal when you subtract your cut angle form 90° and you cut that then xgo back with a 90 and cut the face aannnndd yeah just dint work the best

Never even owned a sawzall till I had to cut a cast sewer pipe...Use a circular saw for everything, even if it ain't pretty...LOL

When you think you are done with those blades keep them around for the project you know is going to destroy and go through a few blades.

You are correct. I guess WD's wife was wrong about his carpentry skills, but he's learning. lol

Dang wolfie .. handy guy like you. Not sure just what your cutting. But you know you can clip something on shoe of your saw after itself to 45. Cheat your angle. Won't cut deep thought.

Mac

I use diablo. I run mostly milwaukee gear but not a fan of their sawzall blades honestly. I typically do a lot of window,doors and decks, but can do high end custom trim and staircases and such. Diablo is all I use unless i'm doing a higher end job.

for the sharp angles, can't just pull the guard back on your saw to start the cut instead of run a sawzall?

Well I was trying this method, ( 9:50 mark) and it worked but not the best , had to keep going back and cleaning/ finishing the cut with a hand saw so

Nothing wrong with a hand saw.

Yep, and I take every opportunity to avoid using one, lol

I prefer Lenox, depending on what you’re cutting a jig saw is handier than a sawzall.