Any one have experience with this clip. I can see were it would hold secure as far as up or down on the 3/8 ths. rod but does it hold good enough so it will not swing left, or right in case rat or mink doesn't go through opening but hits the side. I'm only talking about 110's. Hope I explained it well enough.

I bought a couple dozen to try this year, I was wondering the same thing, but they have been great, I will not have a 110 without them soon.

I have been using them on 3/8 fiberglass rods, they haven't moved a bit and have been a darn good time saver.

Well as far as I'm concerned My question has been answered. Time to get some. Thanks for your replies.

Haven't had any issues with the 330 clips with spinning. I could see possibly having spinning if the animal hits the frame of the trap. But you would of missed that one anyways

Hi Furback,
In MOST situations you will not have any spinning and if your centered in a run you should be fine. I do want to point out that where you CAN experience spinning is if the rod is not solid, like if its not very deep in loose gravel and there is a swift current. Essentially the rod spins causing the whole setup to spin. Again, in most situations it should not be an issue, but if you do run across it, a simple cross/corner stick with fix it in a hurry... Thanks PineDoggin, Sagevalleycalls and sniperbbb for your patronage and helping furback out!

Good Luck