Just wondering what mods you have done to your drivers. Also, are there any out for sale that have a welded nut or hitting head on it already. Thanks!

Stalker Fabrications has an awesome driver that I believe is heat treated and has a big striking surface on it. He is on here and has a Facebook page as well

Thanks Terrence

Stalker

7/16" cold roll steel, when it bends or mushrooms throw it away, about $3.00/per.

MTP sells a hardened one for their Super Stakes.

I usually put the end on a grinder and put a little bevel on it so it pulls out of the stake easier.

I paint the end of mine orange, otherwise it'll get lost.

casenite will harden them to a degree and available from Brownells here https://www.brownells.com/gunsmith-...-sku083000033-27119-52952.aspx?rrec=true

works great on gun parts and I've used it on drivers too

All I do to mine is take it to the bench grinder when it gets mushroomed out. I just have the cheaper one mtp sells. I did get one stuck pretty good one time but if you just bevel the end a little and clean it up every so often it works just fine

Stalker, and MTP have the good ones as stated above. I recently made one out of cold rolled 1018 and case hardened it.
it works well in testing, I will put it through the ringer this season.