I order the wrong base plates. I order for #2 northwoods . I needed for #3 northwoods. I just have 4 #3 northwoods to do. Would it hurt to use the #2 base plates on #3 traps? There just a hair short on each end. Base plating them just for bobcat trapping. I was thinking to run a bead at the end where it isnt cover. Would that work? I was going to make the bottom of trap level across.

It should work, i did the same thing ten years ago . Im still using them #3's they are a 1/2 " short on each side and no issues.

Ok thank u. I don't have time too send back get others put on. Then dye traps and dip in fmj before season .

I dont see why they wont work. Even if they were short a 1/2 inch from each end they will still take the flex out of the trap base plate itself.
J

Yes it will work.that 1/2" or less will never flex,especially from a bobcat.

you'll be fine......1/4" round rod works well and is cheaper.....next time.

Hi are you using a bending tool on rod?