I make my own. A 15" or so length of 2" or so green branch I cut in summer when green and I'm trimming tree limbs. One end cut off flat, the other I sharpen with my knife (easy when wood is green). The dry a bucket of these in my garage. In fall when we have a little fire going in the firepit out back unstick the flat ends in for a few minutes just until blackened and smoked up but not on fire. Pull them out and back in the bucket they go. Later I drill a couple 1/2" holes with a wood bit drill these about 2" and 3" down from flat end. One hole one direction, then turn the stick and drill another perpendicular to the first. The holes are the lure and bait holders and will be above ground when pounded in at a set. Holes going different directions catch the breezes from different directions. When fully dried they are rock hard and pound in easily.
When i use them at a set for coyotes, just hammer one in sharpened end first into the ground and at an angle toward where you bet the trap. Bed the trap in front. Bait and lure it up, and walk away. You can also stuff a little sheeps wool or weeds into the drilled holes and use urine for a post set too.
That fire blackened ends really stick out even in a cornfield stubble, mowed hay fields, bean fields, and especially on snow. Makea a great trap marker in snow too. I've made and used these for years. Sort of a natural pipe if you will but with a little fire blackening and they just work well for me. Easy to reuse them too. The more they get chewed on and slobered up after a catch, the better. I have to credit Charlie Dobbins for this, I picked it up from his land trapping book and first couple seasons I used them I was hooked and have made them every since...maybe since late 80s I believe.
Jim
Last edited by jabNE; 12/17/19 07:10 AM.