Thank you SNIPER for you kind reply.

I ordered another roll/spool from another sponsor.

Hopefully, should be better next time around. (Not Chinese crap)

I do not think there will much China stuff will left in the country for how it is going. For all that broke out and also the trade with them. I so far have not had problems with the cable I use for snares,I forgot where it is made.

Good move,Bill.With cable restraints,coyotes are alive and fighting the cable much longer than with snares,even on a 24 hr check,they can chew off a lot of cable.It pays to use the best.Good luck.

Should have bought 1X19 for those CRs.

I have used cast cable in the past, its really not hard to bend it back into shape for the loop of the snare. It has a "memory" of how it was wrapped on the spool, all you have to do is bend it back against that "memory" for the short section that forms the loop.

I wish you were closer Bill, I'd show you how its done, but really it's no more difficult than running it through your fingers a time or two. Just make your snare and look at it from the side (not the way the animal enters it) so you can see how it hangs then simply bend it gently, or more accurately, curve it, the way you want it to go. Honestly after a few it will literly only take you a few seconds to get the loops hanging nice and straight. I have done it thousands of times.

Check your P.M.'s Bill

cable was rewound without consideration of the memory.
Just make drowners with it.
just