Is Dan Reich, the maker of Pogo Anchors still in business? He used to be a regular on the convention circuit. I haven't heard about him in many years.
I know he was busy raising kids, and I believe building a house at one time. I was reading a post about trap anchors and got to wondering about him.
He used to post a picture of a pile of drivers when he was leaving for a convention, if you guessed the correct number of drivers in the pile there was a
prize. Hope he is still doing well.

I don't know about him, but I love Pogo anchors.

You can find him on Facebook, I believe MTP took over the pogo line but I could be mistaken.

POGO is alive and well.
I talked to him at the end of august. I believe he went to the Wisconsin Convention.

I always liked his shirts too

Pogos rock!! All I use now to anchor my land sets

I like pogos , because I can make my own without waiting on others being shipped if I run out.
Simple and easy to make.
I bought 100's of 1 1/2 and 2 inch washers and never run out of them.
Just make sure you use the driver , pull up and twist and pound down again to set it flat.

I’ve been using homemade pogos since the late 90s in my clay, sandy ground that has no rocks. I would buy 1.5” fender washers by the 1000 and 30D nails, NEVER had a “stake-pumping” coyote ever budge one!! It’s all about square inches of surface area displacement! Making pogos is a good shop project in March! LOL

I've used them in sandy river bottom and also muck and never had one pulled up.

On my 3rd Pogo driver in 20 years LOL

Im hard on equipment