What's eveyone using for carbon shafts ? Having a hard time seeing a point in anything past one of those little harbor freight table top cut off saws and a some kinda ruler guide set up like this


But what's up veyon else using?

I think that little harbor freight would work , I have one I use for brass

cutting 5.56 at the shoulder for 300blk

cut , form/size , run the second time size , trim and load

I use the harbor freight saw and it works just fine, if you’re careful it makes square cuts also. But if square cuts are an issue you can buy an arrow squaring tool pretty cheap. My saw came with a metal blade, but they sale another tool that uses a carbon blade and is the same arbor size so I bought one of those blades and put on it. The carbon blade is a little larger so I did have to notch my blade guard to make everything fit.