$49.62 if the motor runs, and the blade don't need replacing. I'd offer 25 cents and see where negotiations go from there.

5 bucks scrap?

Tree fiddy, plus tax

How wide is the bed?

I paid 100.00 Canadian , last month for one 42 inch by 6 inch bed. good motor and good condition. This appears to be worth looking at if it , suits your needs old 243

Proly cost you 25 bucks to get it hauled off.
so -25.00

6”

I would ask what they want and go from there. I hate robbing or undercutting someone, but I also hate getting taken or paying too much also.

If they insist you make an offer, I say 25$.

If you cleaned it up, took some steel.wool.to it, oiled and waxed it, it may not look to bad.

Keith

That's what I'm gonna do, Maybe hit it with some paint and give it to my SIL for Christmas. She does a lot of woodworking but I don't think she has one.

Next question. What is it? A planer?

It looks like it is worth a hernia and a bulged disk to me.

It’s a jointer.

lol

Spot on with that assessment.

Maybe she’ll use it but I have had delta for 30 years and I think it’s been used 10 times maybe, so I wouldn’t pay much for it.

She's wanting to make some cutting boards and chess boards to sell in her shop so it may come in handy.

Make sure the bed is square to the the fence and there no low spots in the bed.

I use mine all the time. It’s the first step in milling rough cut lumber. I use it to get one flat face and one flat edge square to that face.

Then on to the table saw to get the second edge square to the jointed face and parallel to the jointed edge.

Then on to the planer to get the still rough face flat and parallel to the jointed face. Also planed to finish thickness.