Had these molds for a few years after a stupid buy figured it's about time to put em to use . Only doing the single cavity right now , makes some pretty pills I think

Good looking bullet

Those are sexy.

Are those Ohaus bullets made for gas check?

Yeah want really sure since I'm used to working with smaller stuff but got it confirmed so brought out the other that was a plain base

Gonna be a bit of a shame to powder coat them not gonna lie....might try to use the lube sizer by that thing annoys me to no end

Why powder coat?

Gotta protect the barrel from the lead one way or another and that leaves you either a lube of some sort or a jacket . Powder coat just acts las a polymer jacket. Protect the lead from the barrel barrel from the lead and the bast of the bullet from the hot gasses with a plain base bullet instead of copper gas check on the bottom of the bullet

Thanks that makes sense.
The ones we used were not coated,
but lubed and checked if I remember right.
125gn I liked.

I recently was given back my old jig molds.
I'll be the next one cookin.
Those could use color.

Be careful of loading them with Lil Gun or H110 and powder coated 125s, serious leading.
I've done better with Hornady XTPs ..

So think they came out pretty nice first time using this JD Green

I like that green, Wolfie.

I've never tried powder coating cast bullets. I found the plain base worked well in 38 specials, but when you stepped it up to heavier 357 mag loads a gas check was nice. I use the Lee Lube on all my cast bullets, been very happy with it and no luber/sizer needed (obviously still need a sizer if your bullets are oversize, but most of my Lee molds cast bullets that I can load without sizing, I tend not to use the couple molds that cast bullets large enough I have to size)