For bgs, stripped down to new metal with a light surface rust. Should I use rusty metal primer or enamel from rustoleum? Does it matter? Longevity wise?

I have used both as well as mixed as I ran low. They both work well. The key to a good paint dip is thinning. I only use acetone and run a ratio of 40% paint to 60% acetone and have had good luck with even thinner paint.
I have tried paint thinner and had poor results. Use acetone with the above ratio and you will be happy. And be sure to mix well.

I do 2:1 acetone to paint for rusty metal primer and than 1.5:1 ratio for flat black on footholds.

Thats starting from more or less bare metal.

I think the primer is important for “dirty” bare metal.

Latex paint works just fine.

Do NOT cut latex with acetone. You will not be happy with the results.

Use water it works just fine and It's cheap.

To paint your house maybe.

My BGs are dipped in latex paint and haven't been re dipped for at least 5 years. And they are used for ADC work in the summer and again during the fall trapping season. And they still look good.

I always use the rusty metal primer mixed with flat black use 60:40 ratio and I normally add more acetone while I’m dipping. It’s normally 90 degrees when I paint so the acetone evaporates quick you want the paint dripping off the traps and if you notice it’s to thin and you can see rust still just re dip traps after twenty minutes or so

Latex paint?? REally?? And I just spent 100$ on rustoleum and acetone LOL
What kind of latex paint? Just curious at this point

You can find cheap latex paint at the box stores, usually a spot for wrong color returns or mixing mistakes...just find a color you can live with, lol...no idea on mix ratios, assume you thin it down a lot, and redip if it doesn't cover well, Beav will tell you the ratio I'm sure...

Acrylic latex paint. I go 50/50 water to paint. But to be safe start out with a gallon of paint and 2 quarts of water mix well. If that works for you so, be it. If not add more water. Mix well when dipping the paint has a tendency to settle to the bottom of the container.

I used latex once.

Just once.


Takes forever and a day to dry. Isn’t near as tough as a good enamel.

And the metal continues to rust under the paint as it never truly adheres.

Save your leftover Mix in paint cans and re thin layer on it lasts a few years but the acetone does evaporate to a degree

Dye and wax…

I have to disagree on drying time. The right paint thinned to the right consistency will dry in 20 min. I guess you have never used Killz primer.
If your paint never dried, you were doing something wrong.


Les no way am I dying and waxing my BGs.

Footholds only, I rattle can rust oleum on my body grips. It doesn’t address a skunky trap like dye will…