nope. I have
a couple variable DC power suppliesOne is 0-30v, 0-10 amp, the other 0-60v, 0-5 amp. The variable ones are far better. You get dials for course and fine voltatage adjustment and course/fine adjustment for amperage. You basically dial in the voltage limit and current limit, then turn it on. If its not connected to anything, it sits at the configured voltage but the current is 0 because its open circuit. If it short circuit it, it supplies the configured current, but the voltage is 0 because its a short. Or it can be anything in between. IMO variable electronic power supplies are far better than the old fixed rate power supplies.
For example,...
A few weeks ago I had a 12v diaphram style pump that wasn't working. Its like what's on a pesticide spray tank. When the pump worked it drew around 5 amps, but recommended a fuse size of 10 or 15. So I set the power supply to 13v, 5 amps, and turned it on. The variable DC will not exceed either configured limit. The voltage dropped to 0, the current was sitting at 5 amps. No popped fuses, no damaged power supply, no damaged rotor. The display on the power supply said it was supplying the current limit at 0v and the pump wasn't working. So clearly the rotor was locked. So I took the pump apart, discovered seized bearings (which I replaced) and put it back together. Then it worked fine. I saw not only did it run and pump water, I saw the voltage and current draw on the display.