Scheide and I share the same gutter on this with the exception I use 3/8" rebar stakes. No other tools, just trap (1.5 LS - old cast jaws or coil springs) , 2 rebar stakes (he uses wood), 1/8" drowner cable (he uses 3/32), cable length 6' and 10' color coded (he uses only 6'). His soil is central Nebraska mixtures of alluvial deposits with predominantly sand, small areas of gravel, then silt and clay. Ours is loess soil of predominantly silty clay loam. I use the rebar to dig and round a pocket hole, a small handful of feathers shoved in, set and stake trap, squirt lure on bank and leave. Skip the feathers and my mink #'s go down. Use Christmas tinsel if no feathers saved from last bird season. Have tried anchors, wood, PVC, tubing wheel rotors etc., etc., as drowner ends, always go back to rebar and can use 3/8" over 1/2" here. I needed 1/2" when I was in MN due to sand and gravel soils. Once in a great while I have sites that have rip rap or crushed concrete lining upper and lower substrate (dam face - plunge pools - erosion protection banks etc.) so am forced to used bags filled with rocks on either or both ends of the drowner but can position the rocks/concrete into a cubby/pocket so no digging. This is where some of the 10' drowners come into play (along with shallow flat creek banks). Fill bag with on-site stone, wire bag end shut with 14 gage and tie the drowner to that wire, make sure trapped critter CANNOT reach upper bag and toss lower bag into the deeper H2O. These were STD 1 way drowner set ups for multi species water trapping (like Scheide says for 40-50 years) for us. This was prior to 2001 when the grizz gettr' hit the scene for coon - which made every every guy/gal in the U.S. with strength to set one - a "coon trapper". My experience. ................the mike
Last edited by Wife; 10/01/26 07:21 AM. Reason: added word