Any one know where i could get replacement coil springs for victor #3 square jaw? The end that goes under the trap frame is a half inch longer then any others I've seen. I tried the universal springs from F&T and they are to short.

You may have to be creative and try other trap springs. Try to order a set for an mb650, I do know that you can order those at FNT

I have some 650s and 550s and neither of those will work. Thanks for the response though.

What if you put a roll pin on the end of the spring and used it as an extension so it could reach the frame? Could probably get both spring ends to fit in one roll pin. Center the roll pin where it needs to be, weld to the frame and then insert each spring into it.

That just might work. I've gotta go in to the hardware store today anyway so I'll take a look. Thanks for that idea.

Sterling fur may have them.

Just add 2 more and make it a 4 coil. that might be your best bet on those.

The Roll pin idea worked well. Thanks for the all the responses.