Anybody use the F and T 46" stabalizers for BELISLE bodygrips? If so how is the fit? Also can you run them with triggers on bottom? Will the dog clear the top crossbar when firing? Thanks

Anybody?

I don't have belisle 330. I have duke 330 magnums and the new duke copy of belisle 330 and the f and t 46" h stands I can check tomorrow.

I’m not sure what brand I use, but they’re similar. Getting them to stack is tricky by yourself but once you close the arms the stand usually holds the top one in place. I bring zip ties if it doesn’t, I put the tie on the stand arms just for a little ledge for the top trap to sit on. Trigger on the bottom isn’t a problem because the dip in the bars near the base, trap bottoms out on the stand and there still should be a good gap on the bottom. Got a lot of doubles under the ice.

Yes they will fit a Belisle just fine. No you can't run the trigger on the bottom if you have the trap set all the way into the bends of the stand. If you want triggers on the bottom lift the trap up an inch or so off the bottom of the stand. It won't be as solid because the trap isn't fully locked into the stand but it will work

Interesting. Dam Beaver sells the same looking ones with loops at the top and there should be room. I'll take a better pic of mine with a couple 330's stacked in it later, but I can bottom it right down, trigger on the bottom, and there's still a gap similar to this crappy pic. I know this isn't a Belisle in the pic.

F and t 46" H stand with duke 330 super mag.

JAB357 will that trap fit all the way down on the stand?

It will fit if you use first notch on dog

Not much room for wadder boot tho!

Thank you! That's what I've been looking for. I always use the end notch anyway because I target otters frequently.

Here we go. Zip ties on the stand arms to support the top one. This time the zip ties weren’t required.