I bot from MTP about 15 yrs ago. I suffered from the price then maybe low 40 s. lol Now it will compress but not release. Is there a fix?
Thanks

Yes, one way or another I’ll provide a fix! lol
15 years ago is about the time we switched to the better drive unit and the square black powder coated tube. Is the tube on your setter round or square like one in pic?


Rubbing the push rod with steel wool or abrasive pad followed by wiping with dry cloth or paper towel will remove any residue that may have built up on rod. Residue caused thumb release to stick a bit on rod not letting it “re-set” for next stroke.


Also, oiling lightly where indicated on card will keep handle from sticking.

Let me know how you fare with the above.

Good to know-probably was in the instructions lol

Trapset. Thanks for info. Will work on it tomorrow.

Great customer service Shawn!

Thanks much Jayme.

080808, one more thing you can do is turn the push rod left a 1/4 turn or so. That way gripping plates and thumb piece start grabbing new steel on the push rod. It’s one of the improvements on the 2nd gen setter, the push rod rotates 360 so you can always find new meat to grab. Usually not needed for the first several years but if you’ve had your setter for 15 years it might be time. lol

Most rods just rotate on their own with use and transport but some need to be turned by hand the first time just to get the rod loosened up. Usually works best to turn left the first time, after it starts turning freely you can turn left or right.

Trapset. Lubed as suggested and will work on it tomorrow. My wife came home from hip replacement 2 days ago and I’m learning how to cook again. Mine has square tube. Keep you posted. Thanks for everything so far.