Pretty easy fix , with the right tools ..
As others have said

I appreciate all the recommendations!

Yep a good gunsmith

Just run up to Jaquas in Findley and trade it for a Fox or Parker.

https://www.supplyhouse.com/Hilmor-Tools-1839009-Swaging-Tool-Multi-Swage-Punch-5-Sizes-1-4-to-5-8 This would most likely fix it;

As has been mentioned several times. Gunsmith, mandrel or hydraulic dent raiser. Simple fast and far more economical than cutting. You'll likely never see the repair if done by a competent smith.

Don't forget the choke is on that portion of the barrel. I would: make a small anvil to fit inside the barrel and very carefully use a small hammer to tap it eyeball round, then shoot it to see what happened to the choke.

Do you know the maker?

x2

I don't. Only a person's names engraved on it. I can take a picture of the entire gun if that helps.

Please do….. I really like side by sides…..

I’d be interested in seeing it

If it has no collectors value, might consider installing a screw in choke system.

https://www.gunsinternational.com/g...s/shotguns-belgium-double.c732_p1_o6.cfm

It's a Belgium gun with damascus barrels. You should do some more serious research on it. And check, but I don't think its safe to shoot modern shot shells in it, they have too high of pressure for those barrels, if I recall correctly.

This is indeed a low end Belgian double with twist steel barrels. Not sure its worth fixing. Missing both hammers and no remaining stock finish. metal is also without finish. Please don't let anyone shoot it. Would make a nice wallhanger.

Thank you so much!! You are awesome. I knew i came to the right place to ask.