Messed with these #10 cans finally. I've been planning on using them for skunk on a long loop but never got to it now we don't have a lot of them.

Had the photo on my phone so I used that to post what a cluster with the tiny symbols. It took a dozen trys to type that one line. LOL Jumped on my iPad now.

I need to come up with a better way to hold the traps in place those cords won’t last very long but I’ll test them out tomorrow then. I’ll look into traps that might fit the can better but the can does make a solid backing for a 120 coni. It’s the old badger issue of round hole square traps. It’s a 6 inch circle but spring room is needed maybe RPG has something that fit the opening better.

That's the way it works, same boat here.
Think we got all that are to be had for now.

After thinking about it wire would be better than the cords pulling on the springs working against a guy and wire is easy to replace when the time came, leaving the wires loose on the springs I would just not wire them tight.

The RPG 155 5 inch looks like a possibility I’d prefer 2 springs incase I get a coon. Their 110 is 4.5 inch so adding a second spring might be possible if that’s a better fit.

they make little bungy cords

They would get chewed up anyway the smaller ones are cheaply built that I’ve seen, wire would hold up better.

I have a possum dragging my baits out of a cubby and a place with a big junk piles that’s a vermin magnet I’ll put 2 there and 2 near the junk piles.

Try some magnets.

I need to try some of the smaller spread conis the Belisles are not as solid as I need them to be pressed up against the front of the cans. I did set 3 cans 2 at the junk piles and one to protect a cat cubby that a possum keeps messing with. I had 105 pics on that chip cam 102 was of that possum.